THE ALUMINA-ON-ALUMINA FRICTION COUPLE: A MULTICENTRIC PROSPECTIVE STUDY

Abstract

Introduction and Objectives: This is a prospective analysis of clinical and radiographic outcomes of total hip prosthesis with alumina-on-alumina friction coupling implants performed at two hospitals.

Materials and Methods: This study analyzes 60 prostheses with alumina-on-alumina friction coupling (Ceraver-Osteal) (May 1999-May 2002). The Cerafit cup was used in association with 32 Multicone-HAC stems and 28 Anatomic-HAC. Of these cases, 36 were male, and 24 were female, with average age being 47.05+/−12.60 years. Mean follow-up time was 2.3 years. There were no lost or revised cases. Radiographic analysis was done according to Johnston et al., and wear was assessed using the Sychterz method in a special computer program (Auto-CAD R14).

Results: All cases had good clinical and radiographic outcomes. There were no revisions or loosening of the implants. There was one dislocation and one intraoperative fracture, which were both treated by conservative means. There were no infections. The distance between the centres of the femoral head and the cup on the initial radiograph (position zero) was 2.49+/−0.70mm. This measurement stayed constant with time, and no changes were observed associated with so-called early wear or initial seating. Mean wear with respect to a reference of position zero was 0.0184+/−0.0187. This figure is below the error level of the measuring system and thus is not measurable.

Discussion and Conclusions: The alumina-on-alumina prosthesis (Ceraver) yields positive clinical and radiographic results at 4 years. Even though the alumina partially distorts the radiographic image, no evidence of early wear due to seating of the components was observed at four years of follow up using the Sychterz digitalized method.