Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

O3464 COMPUTER ASSISTED DYNAMIC HIP SCREW INSERTION: EARLY CLINICAL EXPERIENCE



Abstract

Aims: Dynamic hip screw (DHS) is a common implant used for extracapsular fracture neck of femur. Accurate placement of the guide wires for the DHS insertion is the most important surgical step. In order to improve precision and accuracy of the guide wire placement, Computer Assisted Orthopaedic Surgery System (CAOSS) was used which was developed at the University of Hull. Early clinical experience in 14 cases is presented. Methods: CAOSS helps in surgical planning and aid surgeons for accurate guide wire placement into femoral neck. After fracture reduction, intraoperative computer based surgical planning was performed using one ßuoroscopic image in two planes each. A trajectory obtained thus helped surgeon to place a guide wire along with the required course under the computer guidance. Results: CAOSS system was used on 11 patients for guide wire placement. Intraoperative ßuoroscopic images of all the patients showed accurate position of the guide wire both in AP and lateral planes. Only 4 ßuoroscopic images were required during the surgical procedure in total, both pre and post guide wire insertion. Conclusions: The computer aided surgery used in guide wire placement for dynamic hip screw insertion proves to be accurate and reliable. It also reduces ionisation radiation exposure to the surgeon, patients and theatre personnel.

Theses abstracts were prepared by Professor Dr. Frantz Langlais. Correspondence should be addressed to him at EFORT Central Office, Freihofstrasse 22, CH-8700 Küsnacht, Switzerland.