Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

HIP RESURFACING FEMORAL NECK FRACTURE INFLUENCED BY VALGUS PLACEMENT AND BONE MINERAL DENSITY



Abstract

Purpose: To examine whether neutral or valgus placement results in greater fracture strength ex vivo, when the femoral neck is notched superolaterally as sometimes occurs during hip resurfacing arthroplasty.

Methods: We loaded 10 paired fresh-frozen notched proximal cadaveric femora (8F/2M, 66 to 80 years) to failure. In each case, the right femur was implanted, using bone cement, with a machined resurfacing component aligned neutrally with respect to the femoral neck whereas the left femur was implanted at 10° valgus. The superolateral notch was 3 mm wide by 2 mm deep directly beside the component. Potted femurs were loaded to failure using an Instron materials testing machine. All 20 femora were scanned using Dual-Energy X-Ray Absorptiometry.

Results: The effect of neutral versus valgus placement was complex. (1) Two pairs slowly crushed; the remaining femurs exhibited a clear fracture. When only the fracture-type failures were analyzed, valgus placement resulted in fracture loads on average 22% higher than for neutral placement (paired t-test, p< 0.05). All femurs failed within the notch, as occurs clinically. (2) Femurs with high bone density (BMD> 0.65 g/cm2) showed a significant increase in fracture load (p< 0.05) whereas femurs with low BMD (< 0.65 g/cm2) were unaffected by component placement. BMD was highly correlated with fracture load (Pearson r=0.87, p=0.0003). (3) The greatest improvements occurred when the neck-shaft angle was relatively low, 128°–132°. (4) Two of ten femurs required larger head sizes at 10° valgus.

Conclusions: (1) Fracture load was primarily controlled by bone quality (BMD); (2) nevertheless, varus/valgus placement did affect the fracture load; (3) the magnitude and direction of this effect depended on fracture type, bone mineral density and the original neck-shaft angle; (4) for the level of bone quality typical of patients undergoing hip resurfacing, and for low-to-average neck-shaft angles (up to 132°), the fracture load for 10° valgus placement was significantly higher than for neutral placement. Funding: Other Education Grant

Correspondence should be addressed to Cynthia Vezina, Communications Manager, COA, 4150-360 Ste. Catherine St. West, Westmount, QC H3Z 2Y5, Canada