Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

JOINT FORCE GENERATES DISLOCATING COMPONENT INFLUENCED BY ACETABULAR LINER HEAD CENTER INSET



Abstract

Previous studies suggested that the shallow Ultra High Molecular Weight Polyethylene (UHMWPE) acetabular socket liner or the liner with no head centre inset can significantly increase the risk of hip joint dislocation. Independent to the traditional neck impingement models, the purpose of this study was to investigate an additional dislocation force pushing the femoral head out of UHMWPE acetabular liner bearing under direct hip joint loading and the factors including the head centre inset affecting the magnitude of this force. The 3 D Finite Element Analysis (FEA) models were constructed by (30) 10 mm thick UHMWPE liners with six inner bearing diameters ranging from 22 mm to 44 mm and five head centre insets in each bearing size from 0 mm to 2 mm. A load of 2 446 N was applied through the corresponding CoCr femoral head to the rim of the liner. The DF was recorded as a function of head centre inset and head diameter. The results were verified by the physical tests of two 28 mm head bearing liners with 0 and 1.5 mm head centre insets respectively.

The results showed that the highest DF was 1 269N in 0 mm head centre inset and 22 mm head. The lowest DF was 171 N in 2 mm head centre inset and 44 mm head. The DF decreased as the head centre inset and head size increased. When head centre inset increased from 0 mm to 1 mm, the DF was reduced more than 50%. Two experimental data points were consistent with the trend of DF curve found in the FEA.

We concluded that the new intrinsic dislocating force DF can be induced by the rim directed joint loading force alone and can reach as high as 51% of the femoral loading force. This can be the addition to the dislocating moment generated by the neck impingement. A head inset above 1mm can effectively reduce DF to less than 25% of the joint force. Furthermore, the larger head diameter generates less DF. The DF is likely caused by the wedge effect between the deformed polyethylene bearing and the femoral head. The inset allows the femoral head to be separated from the spherical bearing surface, thus reducing the wedge effect. Our observation of the stabilizing effect trend of the head centre inset was consistent with reported clinical data. However, the increased height of the capture wall also reduces the range of motion. It is therefore necessary to minimize the inset height with the maximum benefit of the stabilize effect. This study suggested the larger femoral head has the advantage of reducing the DF and the stabilizing effect is more effective when combining with the inset wall. The result of this study should provide the guidance to improve acetabular poly liner design for better joint stability.

Correspondence should be addressed to ISTA Secretariat, PO Box 6564, Auburn, CA 95604, USA. Tel: 1-916-454-9884, Fax: 1-916-454-9882, Email: ista@pacbell.net