Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

A920. APPROPRIATE ENTRY POINT OF INTRAMEDULLARY GUIDES FOR FEMUR IN TOTAL KNEE ARTHROPLASTY: USING THREE-DIMENSIONAL DIGIAL TEMPLATING SOFTWARE – ATHENA



Abstract

Introduction: Appropriate femoral component alignment is important for long-term survival of total knee arthroplasty (TKA). Valgus angle of femoral component is recommended as the angle between mechanical axis and anatomical axis of the femur. Intramedullary guide system is widely used for determining the valgus positioning of femoral component. Entry point of intramedullary guide is one of the key factors for determining valgus angle of femoral component. Some investigators have shown appropriate entry points of intramedullary guide, however, it is still unclear. In this study, appropriate entry point of intramedullary guide system was calculated using three-dimensional digital templating software “Athena” (Soft Cube, Osaka, Japan).

Method: Forty-one knees in 34 osteoarthritis patients except valgus deformity (30 females and 4 males, mean age 75.1 years) received TKA and were simulated using “Athena” from January 2009 to March 2009. All cases were grade III or IV in Kellgren-Lawrence index. Radiograph and CT scan image were used for determination of appropriate entry point of femur using “Athena”. The anatomical axis of femur was defined as a line connecting the midpoints of femoral AP and lateral diameter, at 60 mm and 110 mm proximal to the center of intercondylar notch. Two coordinate systems were configured as representation of entry points. One was at the center of intercondylar notch defined as the point of origin in axial view of CT image and the line parallel to the clinical epicondylar axis (cTEA) defined as X-axis. Another coordinate system was the same point of origin but parallel to the line between trochlear groove and the center of intercondylar notch (AP line) defined as Y-axis.

Result: In the coordinate system that defined the cTEA as the X-axis, the average of entry point was 0.3± 0.30 mm medial (range, −4.8~ 4.7mm) and 11.6 ± 0.52mm anterior (range, 3.1~ 16.5mm) to the center of intecondylar notch. In the other coordinate system that defined AP line as the Y-axis, the average of entry point was 2.6± 0.29 mm medial (range, −1.5~ 6.3mm) and 11.2±0.52 mm anterior (range, 2.8~ 16.0mm) to the center of intercondylar notch.

Discussion: In this study, the appropriate entry point of intramdullary guide was slightly medial and about 11mm anterior to the center of intercondylar notch on average. However, individual entry point varied considerably in distance. These data indicates that it is important to simulate the appropriate entry point of intramedullary guide in preoperative planning.

Correspondence should be addressed to Diane Przepiorski at ISTA, PO Box 6564, Auburn, CA 95604, USA. Phone: +1 916-454-9884; Fax: +1 916-454-9882; E-mail: ista@pacbell.net