Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

Research

THE EFFECT OF STRAIN RATE ON WHOLE BONE OF REDUCED MINERAL CONTENT

British Orthopaedic Research Society (BORS) Annual Conference



Abstract

Aim

To investigate the effects of strain rate and mineral level on the stress at failure, stiffness and toughness of whole bones.

Methods

40 ovine femurs were harvested and subjected to either slow [8.56 × 10−3 s−1 (± 1.42 × 10−3 SD)] or dynamic [17.14 s−1 (± 8.20 SD)] loading. Half the bones were demineralised by 20% compared to the original mineral content. These were allocated evenly between the high and low strain rate groups. Dynamic loading was achieved by custom designed comminution device. Slow rate testing was carried out on a Zwick/Roell z005 testing machine.

Results

Strain rate was found to increase the Young's modulus in both the normal and demineralised bone. Additionally the toughness of the bones at failure was found to reduce with increasing strain rate. When comparing bone of normal quality the stress at failure was found to increase with strain rate. However, this effect was greatly reduced when comparing the effect of strain rate on the stress occurring in demineralised bones.

Discussion

These results show that bone has an ability to withstand higher than normal stresses if these are applied quickly and for a short duration (such as would occur in a traumatic event). This ability is greatly reduced when the bone is of reduced mineral content, such as is found in aged or diseased bone.