Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

General Orthopaedics

ACETABULAR CUP PLACEMENT: THE ELUSIVE HOME RUN OF THA

Current Concepts in Joint Replacement (CCJR) – Winter 2014



Abstract

Ideal cup positioning remains elusive both in terms of defining and achieving target.

Our aim is to restore original anatomy by using the Transverse Acetabular Ligament (TAL). In the normal hip TAL and labrum come beyond the equator of the femoral head therefore if the definitive cup is positioned such that: It is cradled by the TAL; Is ideally no more than 4mm greater in diameter than the original femoral head; Sits just deep to the plane of TAL and labrum (this means that normally we leave the fat pad intact and do not ream down to the true floor).

That should restore joint center in terms of height and offset. If the face of the cup is then positioned parallel and just deep to the TAL and psoas groove that should restore original version. We still use TAL for version in dysplasia because we believe the TAL and labrum compensate for any underlying bony abnormality. However in dysplasia the TAL and labrum fall short of original femoral head equator and therefore in such cases we ream down to the true floor if necessary and use a cup which is often smaller than the original head.

Inclination represents a greater challenge and TAL should not be used as an aid to inclination. Our research has shown that errors in postoperative x-ray inclination above 50 degrees are generally caused by errors in patient positioning when in lateral decubitus. Consequently great care needs to be taken when positioning the patient.