Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

General Orthopaedics

THE INFLUENCE OF THIRD BODY DAMAGE BY CALCIUM SULPHATE BONE VOID FILLERS ON UHMWPE WEAR

The International Society for Technology in Arthroplasty (ISTA), 27th Annual Congress. PART 1.



Abstract

Introduction

When third body particles originating from bone cement or bone void fillers become trapped between articulating surfaces of joint replacements, contact surfaces may be damaged leading to accelerated wear and premature failure of the implant. In this study, the damage to cobalt chrome counterfaces by third body particles from PMMA bone cement (GMV, DePuy) and various bone void fillers was investigated; then wear tests of UHMWPE were carried out against these surfaces.

Methods

Third body particles of polymerised GMV bone cement and the bone void fillers; OsteoSet (with tobramycin), Stimulan and Stimulan+ (with vancomycin and tobramycin) (provided by Biocomposites Ltd.) were trapped between an UHMWPE pin and a highly polished cobalt chrome plate. A load of 120N was applied to the pin and using an Instron materials testing machine, the plate was pulled beneath the pin to recreate third body damage [1]. The resulting surface topography of the plate was analysed using white light interferometry (Bruker NPFLEX). Pin on plate wear tests of GUR 1020 UHMWPE pins were carried out against the plates perpendicular to the direction of damage for 500,000 cycles in 25% bovine serum using a 6-station multi-axial reciprocating rig under conditions to replicate the kinematics in total knee replacement. Wear of the pins was determined by gravimetric analysis and results were compared to negative (highly polished) control plates and positive controls scratched with a diamond stylus (lip height 2µm). Statistical analysis was carried out using one-way ANOVA with significance taken at p<0.05.

Results

Following damage simulation with Stimulan and Stimulan+, no scratches could be seen on the surface of the cobalt chrome plates using a stereomicroscope under 63× magnification (Figure 1). Table 1 shows that OsteoSet caused surface damage with the highest density of scratches, which had a greater mean lip height than those caused by the other third body materials. Stimulan+ caused significantly (p=0.002) fewer scratches than Osteoset and the surface damage caused by Stimulan was below the resolution of the surface analysis measurement technique used.

The pin on plate wear test showed that under the test conditions used, the wear of UHMWPE was similar (p=0.108) for negative control plates and plates scratched with third body particles and a significant (p<0.001) increase in wear was only observed against the positive control plates [2].

Discussion

This study shows that third body particles originating from bone cement and bone void fillers can damage the surface of highly polished cobalt chrome plates and that materials of similar composition can cause varying severity of damage. Wear tests against plates damaged with third body particles did not significantly affect the wear of UHMWPE and to significantly increase wear, scratches needed to have a lip height of 2µm or above.


Email: