Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

General Orthopaedics

PATELLOFEMORAL AND TIBIOFEMORAL FORCES IN DEEP KNEE FLEXION

The International Society for Technology in Arthroplasty (ISTA), 27th Annual Congress. PART 1.



Abstract

There have been a large number of studies reporting the knee joint force during level walking, however, the data of during deep knee flexion are scarce, and especially the data about patellofemoral joint force are lacking. Deep knee flexion is a important motion in Japan and some regions of Asia and Arab, because there are the lifestyle of sitting down and lying on the floor directly. Such data is necessary for designing and evaluating the new type of knee prosthesis which can flex deeply. Therefore we estimated the patellofemoral and tibiofemoral forces in deep knee flexion by using the masculoskeltal model of the lower limb.

The model for the calculation was constructed by open chain of three bar link mechanism, and each link stood for thigh, lower leg and foot. And six muscles, gluteus maximus, hamstrings, rectus, vastus, gastrocnemius and soleus were modeled as the lines connecting the both end of insertion, which apply tensile force at the insertion on the links. And the model also included the gravity forces, thigh-calf contact forces on the Inputting the data of floor reacting forces and joint angles, the model calculated the muscle forces by the moment equilibrium conditions around each joint, and some assumptions about the ratio of the biarticular muscles. And then, the joint forces were estimated from the muscle forces, using the force equilibrium conditions on patella and tibia. The position/orientation of each segments, femur, patella and tibia, were decided by referring the literature.

The motion to be analyzed was standing up from kneeling posture. The joint angles during the motion are shown in Fig.1. This motion included the motion from kneeling to squatting, rising the knee from the floor by flexing hip joint, and the motion from squatting to standing. The test subject was a healthy male, age 23[years], height 1.7[m], weight 65[kgw].

Results were shown in Fig.2. The patellofemoral force was little at standing posture, the end of the motion, however, was as large as tibiofemoral force during the knee joint angle was over 130 degrees. The reason of this was that the patellofemoral joint force was heavily dependent on the quadriceps forces, and the quadriceps tensile force was large at deep knee flexion, at kneeling or squatting posture. The maximum tibiofemoral force was 3.5[BW] at the beginning of standing up from squatting posture. And the maximum patellofemoral force was 3.8[BW] at the motion from kneeling to squatting posture. The conclusion was that the patellofemoral joint force might not be ignored in deep knee flexion and the design of the knee prosthesis should be include the strength design of patellofemoral joint.


Email: