Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

General Orthopaedics

BEHAVIOUR OF A PASSIVE FILM OF IMPLANT METAL UNDER DIFFERENT FRETTING CONDITIONS

The International Society for Technology in Arthroplasty (ISTA), 27th Annual Congress. PART 2.



Abstract

Introduction

In these three years, many troubles have occurred in the arthroplasty by hip joint prostheses with metal on metal sliding surfaces. Anomalous reaction including a pseudotumor, which is supposed to be caused by the metal ions released from the implant surfaces, is the most serious problem for the patients1). This problem seriously confused us because there is the fact that ion release has not hardly occurred between a head and an acetabulum, where usual wear proceeds. The important clue was the stain that was sometimes found on the surfaces of the taper junction of retrieved prostheses. This stain has been generally estimated the evidence of the fretting corrosion. It has not been clarified why short range sliding enhances the corrosion, yet. In the present study, to elucidate this problem, we observed the behavior of the passive film of implant surfaces under the sliding conditions of fretting, which is presumed on the taper junction.

Materials and Methods

In the present study, electric potential was measured as an indicator to assess the removal of the passive film of cobalt chromium (CoCr) alloy under the fretting conditions. A wear simulator (FPR-2100, RHESCA, Tokyo, Japan) was used for the testing apparatus with reciprocating motion. A Co-28Cr-6Mo alloy pin (Smith & Nepew, London, UK) specimen was 10 mm in diameter and abraded with the common material plate (Fig. 1). A load of 1 N was applied to a pin. The electronic potential between the pin and the Ag/AgCl reference electrode (HX-R5, HOKUTO DENKO, Tokyo, Japan) soaking in the PBS(−) as simulated biological fluid were measured using a high impedance electrometer (HE-104, HOKUTO DENKO, Tokyo, Japan) (Fig. 2). The sliding width was chosen 0.5–10 mm. The reciprocating cycle was chosen 0.5–2 Hz. The changes in the electronic potential of CoCr alloy were recorded during the sliding motion together with under the static conditions before and after the sliding motion.

Results and Discussion

The electronic potential lowered with the onset of the sliding motion (Fig. 3). The reduction in the potential enlarged with the increase in the cycle at any sliding width. The return of the potential, which might correspond with the repassivation on the damaged surface, was observed after the halt of the sliding motion. On the other hand, the time constant of the return curve of the potential rose with the expansion of the sliding width. From these results, it was found that the passive film of CoCr alloy that was removed with the sliding motion can repassivate when the interval of the motion is sufficiently long. On the other hand, repassivation is slow when the interval of the motion is short. This means the small amplitude, as the fretting, must enhance the metal ion release.


*Email: