Advertisement for orthosearch.org.uk
Orthopaedic Proceedings Logo

Receive monthly Table of Contents alerts from Orthopaedic Proceedings

Comprehensive article alerts can be set up and managed through your account settings

View my account settings

Visit Orthopaedic Proceedings at:

Loading...

Loading...

Full Access

General Orthopaedics

THE CHOICE OF CT VERSUS MRI FOR MODELING OF PATIENT-SPECIFIC INSTRUMENTATION IN TOTAL KNEE ARTHROPLASTY: A REVIEW OF CURRENT EVIDENCE

The International Society for Technology in Arthroplasty (ISTA), 27th Annual Congress. PART 4.



Abstract

Introduction

Increased accuracy of pre-operative imaging in patient-specific instrumentation (PSI) can result in longer-term savings, and reduced accumulated dose of radiation by eliminating the need for post-operative imaging or revision surgery. The benefits and drawbacks of CT vs MRI for use in PSI is a source of ongoing debate. This study reviews all currently available evidence regarding accuracy of CT vs MRI for pre-operative imaging in PSI.

Methods

The MEDLINE and EMBASE databases were searched between 1990 and 2013 to identify relevant studies. As most studies available focus on validation of a single technique rather than a direct comparison, the data from several clinical studies was assimilated to allow comparison of accuracy. Overall accuracy of each modality was calculated as proportion of outliers >3 % in the coronal plane.

Results

Seven studies matched our inclusion criteria. Outlier incidence was 12.5% (9.27–17.4%) with CT and 16.96% (1.2–44%) with MRI (p>0.05).

Conclusions

Current evidence shows comparable accuracy with both imaging modalities for PSI. Outlier incidence is slightly lower in the CT group with lower variation but this was not significant. At present there is not enough published data to convincingly conclude in favour of CT or MRI for accuracy of component alignment. It is our conclusion that CT is more favourable at present due to reduced scanning times, increased availability, and cheaper cost.


Email: