The shoulder is the least constrained of all joints of the body and is more susceptible to injury including dislocation. The rate of recurrent instability following primary stabilization procedure at 10 years of follow-up ranged from 3.4 to 35 %. We describe the outcomes of 74 patients who underwent knotless arthroscopic anterior stabilisation using 1.5 mm Labral Tape with 2.9mm Pushlock anchors for primary anterior instability.

We performed a retrospective analysis of patients who underwent surgery for post-traumatic recurrent anterior instability for 2 years by a single surgeon. Patients with glenoid bone loss, >25% Hill Sachs lesion, posterior dislocation, paediatric age group and multidirectional instability were excluded from this study. Over 90% of our case mix underwent the procedure under regional block anaesthesia and was discharged on the same day. The surgical technique and post-operative physiotherapy was as per standard protocol. Outcomes were measured at 6 months and 12 months. Of the 74 patients in our study, we lost 5 patients to follow up. Outcomes were measured using the Oxford Shoulder Score apart from clinical assessment including the range of motion.

We noted good to excellent outcomes in 66 cases using the Oxford Instability Scores. All patients achieved almost full range of motion at the end of one year. Our cumulative Oxford Instability Score (OIS) preoperatively was 24.72 and postoperatively was 43.09. The Pearson correlation was .28. The t Critical two-tail was 2.07 observing the difference between the means of the OIS. Complications included recurrent dislocation in 2 patients following re-injury and failure of procedure due to recurrent instability requiring an open bone block procedure in one case. We had no reported failures due to knot slippage or anchor pull-out.

We publish the largest case series using this implant with distinct advantages of combining a small bio absorbable implant with flat braided, and high-strength polyethylene tape to diminish the concern for knot migration and abrasive chondral injury with the potential for earlier rehabilitation and a wider footprint of labral compression with comparative outcomes using standard techniques. Our results demonstrate comparable and superior results to conventional suture knot techniques for labral stabilization.

Background

Non-operative cases of mallet finger can be followed up by the hand therapists. Both trust and national policies encourage appropriate indication for follow-up in fracture clinic & cost-effective approach without affecting the patient care.

The scaphotrapeziotrapezoid (STT) joint is one of the key link joints between the proximal and the distal carpal rows. We assessed the relationship between the scaphotrapezium (STm) andscaphotrapezoid (STd) joints using computerised tomographyand hypothesised the ratio of STm is =/< STd joint due to which, the possibility of failure of trapeziectomy due to metacarpal collapse is insignificant. We reviewed CT scans of wrist joints of 113 eligible patientsfrom our wrist database between 2009 and 2014 for our study. 31 patients were randomised for interobserver correlation. Reformatted multi-planar sequences were analysed. The ratio of theSTm: STdin sagittal and coronal measurementswas evaluated. Interobserver variations were assessed using the Pearson coefficient.

The sex distribution included 68 males and 29 females, 49 left and 64 right wrists. The STm area was larger in 86 (76%) as compared to STd in 27(24%). Average trapezium to trapezoid ratio was 1:1.5. Ratio of area of trapezium: trapezoid joint is 0.30. The anatomic ratio of the STm in the coronal and sagittal planesis 0.3 and that of the STd joint is 0.2. Ratio of the STm: STd in the coronal plane is 0.29. Pearson's coefficient > 0.8.

A small subset of patients undergoing trapeziectomy alonefor stage II- IV carpometacarpal arthritis of the thumb are at risk of impingement of the first metacarpal due to collapse. Our assessment of the anatomical relationship of the STT joint with CT scan proves that although the area the STm joint is generally larger than the STd joint, there is no significant correlation on the whole.

Tibial and femoral loosening are major causes for implant failure in total knee arthroplasty. Jefferey (1991) reported a significantly lower rate of loosening when varus or valgus was within 3 degrees of mechanical axis in an eight year follow up. Coulle (Dec1999) reported 48% unacceptable alignment in non-navigated knees and Reed (Aug 2002) reported 35% alignments deviating more than 3 degrees from mechanical axis when navigation was not used.

We report our series of 286 navigated knee replacements using the Aesculap Search system (21 cases) and the Aesculap e-motion versions 4.2, 4.3 and 4.4 (265 cases) between April 2003 and December 2012 by the author (A.D) and analysed the correction achieved against the zero mechanical axis. Postoperative measurement of the angles on long length films was done in 23 cases. This matched with the intraoperative corrections achieved as studied using per-operative computer data stored for every case. We continued to use the data stored in the AESCULAP System to correlate the findings in the rest of the cases. The average mechanical axis achieved was 1.3 degrees. All cases had mechanical axes within 3 degrees.

We were thus able to achieve a high level of correction of the mechanical axes predictable to achieve better clinical outcomes.