Hip abductor tears(AT) have long been under-recognized, under-reported and under-treated. There is a paucity of data on the prevalence, morphology and associated factors. Patients with “rotator cuff tears of the hip” that are recognized and repaired during total hip arthroplasty(THA) report comparable outcomes to patients with intact abductor tendons at THA. The study was a retrospective review of 997 primary THA done by a single surgeon from 2012–2022. Incidental findings of AT identified during the anterolateral approach to the hip were documented with patient name, gender, age and diagnosis. The extent and size of the tears of the Gluteus medius and Minimus were recorded. Xrays and MRI's were collected for the 140 patients who had AT and matched 1:1 with respect to age and gender against 140 patients that had documented good muscle quality and integrity. Radiographic measurements (Neck shaft angle, inter-teardrop distance, Pelvis width, trochanteric width and irregularities, bodyweight moment arm and abductor moment arm) were compared between the 2 groups in an effort to determine if any radiographic feature would predict AT. The prevalence of AT were 14%. Females had statistically more tears than males(18vs10%), while patients over the age of 70y had statistically more tears overall(19,7vs10,4%), but also more Gluteus Medius tears specifically(13,9vs5,3%). Radiographic measurements did not statistically differ between the tear and control group, except for the presence of trochanteric irregularities. MRI's showed that 50% of AT were missed and subsequently identified during surgery. Abductor tears are still underrecognized and undertreated during THA which can results in inferior outcomes. The surgeon should have an high index of suspicion in elderly females with trochanteric irregularities and although an MRI for every patient won't be feasible, one should always be prepared and equipped to repair the abductor tendons during THA.
The ASR™ Articular Surface Replacement and ASR™ XL Metal-on-Metal systems were recalled due to high revision rates at five years. A worldwide clinical follow-up of patients was initiated. This paper summarizes current findings in South Africa (SA) in comparison with those outside SA (OSA). Patients were followed annually, or until revision, from 10 clinical centers worldwide. Data collected includes demographic, surgical, radiographic, blood metal ion levels, and patient reported outcome measures (PROM).Introduction:
Methods:
Rapid mobilisation programs, or “fast track” protocols, are aimed at shorter hospital stays. We found a limited local experience with these programs in total hip arthroplasty in South Africa, and decided to introduce a pilot study at our institution. This pilot study is aimed at the feasibility and safety of a RM program in the private sector setting, as well as a review of the pertinent literature.Background
Purpose
The Valgus knee in total knee Arthroplasty, is considered a more demanding procedure, often with ligament balance a greater challenge than seen with neutral or Varus knees. It has also frequently been suggested that prostheses with higher levels of constraint be used to avoid late-onset instability. Various lateral release techniques have also been suggested in the literature. This study is aimed at assessing the outcomes of an unconstrained, rotating platform designed prosthesis, the LCS, using our technique, in the management of severe valgus deformity. 44 knees in 42 patients with a pre-operative valgus deformity of more than 10 degrees were included in our retrospective series. We analyzed the radiographs for the degree of correction, the angle of tibial tray implantation, and femoral implantation angle, tibial slope, as well as the presence (or degree) of lift off and any complications were noted. In this group, 7 had a Valgus deformity of greater than 25 degrees, with a mean Valgus deformity of 17,36 degrees. The mean age at operation was 65. Clinical and radiological analysis was done Pre-hospital discharge and again post-operatively 6 weeks.Background and Purpose of Study
Methods
To determine the onset, incidence and associated symptoms of adverse noise emissions following total hip arthroplasty (THA) with ceramic-on-ceramic (CoC) bearing surfaces 50 Sequential CoC THA's (45 patients) performed by a single surgeon were interviewed telephonically at an average post-operative period of 12 months. The same group was re-interviewed telephonically 12 months later. Patients who reported noise emissions at either interview were assessed clinically to determine if symptoms could be reproduced.Purpose of study
Methods
The deltamotion bearing system provides a large bearing even with small acetabular components. With optimally placed components the risk of dislocation is extremely low. However the acetabular component is a monobloc system and has significant technical considerations. This is an early series of patients to determine whether a monobloc system can be reliable placed in an acceptable position 66 consecutive deltamotion cases were performed between 1/09/2010 and 31/12/2011. 52 cases were in primary operations and 14 were in revisions. In each case the surgical technique was modified and a trial reduction was performed using the pinnacle trial shell and liner. This enabled the surgeon to determine the optimum combined anteversion before insertion of the definitive component. In no case was a component sacrificed due to failure to achieve adequate press fit fixation. In each case the acetabular component was assessed to determine the angle of inclination and version. 32 cases had follow up of greater than 1 year and these patients were contacted telephonically and interviewed concerning adventitious noises.Introduction
Method
To assess the results of Revision Hip Surgery in which a less invasive technique was utilized in situations where a number of different options was available. The authors rely on an experience of 3,445 hip arthroplasties by a single surgeon over a period of 20 years, of which approximately 20% were revision cases. Of these 617 cases, we report on 175 in which a minimally invasive option was taken. This does not apply to the skin incision, as all cases were adequately exposed. We have adopted this term to describe cases in which a surgical options was taken that resulted in the least morbidity and the shortest surgical time. We postulated that would lead to the best outcomes with the least complications. Acetabular revisions: 1) Isolated polyethylene exchange. 2) Liner revision with cement technique in cases of cup malposition or poor locking mechanism. 3) Revision of cup with a primary prosthesis with significant medial bone loss. Stem revisions: 1) Cement on cement technique. 2) Strut graft and primary stem.Purpose of Study
Method
