Advertisement for orthosearch.org.uk
Results 1 - 5 of 5
Results per page:
Applied filters
Research

Include Proceedings
Dates
Year From

Year To
Orthopaedic Proceedings
Vol. 105-B, Issue SUPP_7 | Pages 5 - 5
4 Apr 2023
Vicary-Watts R McLauchlan G
Full Access

Cannulated hip screws are frequently used in the management of hip fractures. There have been concerns over the failure rate of the technique and the outcomes of those that subsequently require conversion to total hip replacement (THR).

This study utilised a database of over 600 cannulated hip screw (CHS) fixations performed over a 14-year period and followed up for a minimum of one year (1-14). We identified 57 cases where a conversion to THR took place (40 females, 17 males, mean age: 71.2 years). Patient demographics, original mechanism of injury, fracture classification, reason for fixation failure, time until arthroplasty, implant type and post-arthroplasty complications were recorded. Clinical outcomes were measured using the Oxford Hip Score.

The failure rate of cannulated screw treatment was 9.4% and the mean time from initial fixation to arthroplasty was 15.4 (16.5) months. Thirty six fractures were initially undisplaced and 21 were displaced. As one might expect the displaced cases tended to be younger but this didn't reach statistical significance [66.5(14.3) vs 72.7(13.1), p=0.1]. The commonest causes of failure were non-union (25 cases, 44%) and avascular necrosis (17 cases, 30%). Complications after THR consisted of one leg length discrepancy and one peri-prosthetic fracture. The mean Oxford score pre-arthroplasty was 12.2 (8.4), improving to 38.4 (11.1) at one-year. Although the pre op Oxford scores tended to be lower in patients with undisplaced fractures and higher ASA scores, the improvement was the same whatever the pre-op situation. The one-year Oxford score and the improvement in score are comparable to those seen in the literature for THR in general.

In conclusion, CHS has a high success rate and where salvage arthroplasty is required it can provide good clinical outcomes with low complication rates.


Orthopaedic Proceedings
Vol. 103-B, Issue SUPP_2 | Pages 101 - 101
1 Mar 2021
Tantowi NACA Cheneler D McLauchlan G Kerns JG
Full Access

Abstract

Objectives

Osteoarthritis (OA) of the knee causes pain, limits activity and impairs quality of life. Raman microspectroscopy can provide information about the chemical changes that occur in OA, to enhance our understanding of its pathology. The objective of this study is to detect OA severity in human cartilage and subchondral bone using Raman microspectroscopy and explore corresponding mechanical properties of the subchondral bone.

Methods

OA tibial plateaus were obtained from total knee replacement surgery with REC (18/LO/1129) and HRA approval. Medial tibial plateau, representing a major weight-bearing area, was graded according to the International Cartilage Repair Society (ICRS) scoring system. Nine samples (3 samples of each graded as moderate, severe and very severe) were selected for Raman and mechanical analyses.


Orthopaedic Proceedings
Vol. 96-B, Issue SUPP_11 | Pages 155 - 155
1 Jul 2014
Hutchinson R Choudry Q McLauchlan G
Full Access

Summary

The 80% porous structure of trabecular metal allows for bone ingrowth in more than 90% of the available surface. The Nexgen LPS Uncemented Knee using a trabecular metal tibial component has performed well at minimum of 5 years’ follow-up.

Introduction

Total Knee Arthroplasty prostheses most frequently used in today's practice have cemented components. These have shown excellent clinical results. The fixation can however weaken with time, and cement debris within the articulation can lead to accelerated wear. Cementless implants are less commonly used, but some have also shown good long-term clinical results. The potential advantages of cementless implants are retention of bone stock, less chance of third-body wear due to the absence of cement, shorter operative time, and easier treatment of periprosthetic fractures. The posterior stabilised knee replacement has been said to increase tangential shear stresses on the tibial component and increases contact stresses on the cam and post mechanism hence the great debate of cruciate retaining or cruciate sacrificing implants.


Orthopaedic Proceedings
Vol. 94-B, Issue SUPP_XXXVI | Pages 52 - 52
1 Aug 2012
Howard AJ Neilson L McLauchlan G Richards J Evans S
Full Access

The fixation of comminuted femoral fractures with intramedullary nails is commonplace but there remains little work on the mechanical ability of the different diameters of nail available to resist bending. What previous work there is has produced conflicting conclusions. The bending stiffness against the intramedullary nail diameter and the extent of the comminuted fracture is clinically important due to the impact on fracture healing and implant failure.

Intramedullary nails of differing diameters (10 mm, 11 mm and 13 mm) were loaded axially in fourth generation composite femurs with increasing mid shaft bone defects, namely 3cm, 5cm, 8cm and 10cm bones. The loading versus the displacement was recorded for each nail.

A one-way ANOVA analysis demonstrated a significant difference between intramedullary nail diameters and the bending stiffness, with p values of less than 0.012; 3cm mean 12.26 (CI 9.06-15.46) mm, p=0.012; 5 cm mean 10.63 (CI 8.35-12.92) mm, p=<0.001; 8 cm mean 11.04 (CI 8.35-13.74) mm, p=<0.001; 10 cm mean 11.68 (CI 7.86-15.50) mm, p=<0.001. For the 11 mm diameter intramedullary nail, failure occurred at around two times the body weight of an average individual or 1400 to 1800 N. A repeated measure ANOVA analysis of the effect of the increasing bone defect showed a mixed picture, with a significant difference between the 5 cm and 8 cm gap and only a trend towards significance between 5 cm and 10 cm.

Caution should be advised when considering using a cannulated femoral intramedullary nail in a patient with a fracture gap of greater than 5 cm. Further, the mechanical effect of comminuted fractures treated with nails suggests reduced stiffness with increasing length of fracture gap although the picture is complex and explains the divergence of research conclusions.


Orthopaedic Proceedings
Vol. 94-B, Issue SUPP_XVIII | Pages 92 - 92
1 May 2012
Griffin M Mc McLauchlan G
Full Access

The reintroduction of hip resurfacing has raised the possibility of whether it could offer a better outcome in sporting and work activity after surgery compared to total hip replacement.

Questionnaires were analysed from 125 total hip replacement (THR) and 108 hip resurfacing (HR) patients regarding participation in sport in the year after their surgery and returning to work they were employed at prior to their surgery. The two groups had similar average age (61 vs 60) and pre-operative Oxford hip scores (41 vs 38).

Seventy-one of one-hundred and twenty-five THR patients compared to 76/108 HR patients participated in sporting activity in the year after their surgery. When including only patients that played sport before their surgery 54/75 THR and 66/83 HR patients returned to same sporting activity level after their surgery. Of the patients that worked before surgery 35/44 THR patients compared to 70/74 HR patients returned work to after their surgery.

There is significant difference quantity of patients participating in sporting activity after HR and THR (fishers exact test, p value=0.04). However there is no significant difference in quantity of patients returning to sporting activity after HR or THR including only patients that played sport before their surgery (fishers exact test, p value=0.35). There is a significant difference in the quantity of patients returning to work activity after HR and THR (fishers exact test, p value= 0.02). HR has a better outcome in patients participating in sport after surgery compared to THR however there is no benefit for patients that are active pre-operatively. More patients return to work after HR than THR.